2001 Neon spark plug tube rising

Bit of an odd one. I have a 2001 Neon, approx. 160,000km. Car started was idling a bit rough this morning for about 20 seconds after startup. I decided to check the plugs. The spark plug tube in the (I believe) #2 cylinder, had risen up about 1/4 inch above the top of the valve cover. This resulted in the spark plug wire not making solid contact with the spark plug. I checked inside the spark plug hole and did not see anything out of the ordinary. After tapping it back down with a mallet, I took if for a 15km drive (bit of city and highway run). I checked the tube again, and it had risen a bit, but not the 1/4 inch.

The car is running good, smooth idle after reseated the spark plug wires.

Has anyone seen this? Any ideas as to what would cause this?

Mike mlawrenc(at)gmail.com

Reply to
mike
Loading thread data ...

I believe those tubes are held in close-fit holes in the heads with "stud and bearing" type Loctite or equivalent. Either the factory adhesive failed, or someone did some valve train or other work and did not get that one glued in right.

Bill Putney (To reply by e-mail, replace the last letter of the alphabet in my address with the letter 'x')

Reply to
Bill Putney

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.