i just finished a roller 360 for my 85 ramcharger, but now that i have fired it up, the oil filter base adapter seems to be leaking between the block and adapter plate. where can i find a tool to tighten this up, or even better, remove it and install a new gasket underneath?
oil filter base gasket leak
Nov 25, 2006
3 Replies
If it does not have provisions for socket? It should have access for (1/2" square) a extension inside the adapter bolt
found the 3\8 square drive, pulled the plate, is there supposed to be a gasket there between the plate and block?
sqdancerLynn wrote:
No gasket in the center Their is one that fits into the block recess around the edge it's about 3/8 wide mates to the flat surface of the adapter plate
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required