ping glen - 1st gen LHS, engine subframe bushings

rob · 2008-05-24T15:21:28+00:00

96 LHS 3.5L. all 4 engine cradle bushings are beat to hell and crumbling...literally. Alldata who is correct sometimes and sometimes a little bit off is not showing anything about the bushings being pressed into the engine cradle. looks fairly simple, as long as proper safety precautions are taken, and you make sure you get them tight enough afterwards. in my case I'm going to be changing an inner tie rod too and have already done other front end work so an alignment will most likely be done Tuesday morning.to your knowledge are the bushings pressed in ? Also any good ideas you have come across to make the job easier or faster?