I just had the thermostat replaced but it still not blowing hot air. Apparently they also changed the gasket and they flushed it. Any ideas of what else could be wrong??
- posted
18 years ago
I just had the thermostat replaced but it still not blowing hot air. Apparently they also changed the gasket and they flushed it. Any ideas of what else could be wrong??
Sure, if the hoses going into the firewall are hot going in and cold going out and the coolant system is full.........your heater core is stopped up
Glenn Beasley Chrysler Tech
you can backflush it by disconnecting hoses and running water thru it in the opposite direction of normal flow.if both hoses are hot then check inside car for blower system vent doors control failure.they are either vacumn or wire controled.was it working previously?
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.