Program Keyless Remote on a 2001 Chevy Prizm

Does anyone know how to program the keyless remotes on a 2001 Chevy Prizm? Or possibly a Toyota Corolla since they are essentially the same car?

Any help would be greatly appreciated!

----== Posted via Newsfeed.Com - Unlimited-Uncensored-Secure Usenet News==----

formatting link
The #1 Newsgroup Service in the World! >100,000Newsgroups

---= 19 East/West-Coast Specialized Servers - Total Privacy via Encryption =---

Reply to
Just Me
Loading thread data ...

This should be it:

To program a transmitter, there are 3 modes within the remote control door lock receiver. Add mode: This mode is used for adding new or additional transmitters. Rewrite mode: This mode is used to erase all of the previously programmed transmitters and should be used when installing a new receiver. Confirmation mode: This mode is for confirming how many existing transmitters are registered before adding any transmitters. To begin programming, follow the procedure.

Set the following conditions: Ignition off and ignition key out of cylinder. All doors closed except drivers door. All doors unlocked. Insert the ignition key into the key cylinder momentarily and remove it. Using the switch in the drivers door, move the switch to LOCK-UNLOCK 5 times at approximately 1 second intervals within 40 seconds. Close the drivers door, then open it. Again, move the switch to LOCK-UNLOCK 5 times at approximately 1 second intervals within 40 seconds. Insert the ignition key into the key cylinder. Turn the ignition switch from ON-LOCK at approximately 1 second intervals for 1-3 times according to the desired mode.

1 time for add mode 2 times for rewrite mode 3 times for confirmation mode Remove the ignition key from the key cylinder. If the add or rewite mode has been selected, the doors will lock-unlock once or twice at 1 second intervals, once for add mode or twice for rewrite mode. If the confirmation mode is selected, the doors will lock-unlock 0-4 times at 2 second intervals to inform the technician of the number of transmitters programmed. Press a transmitter button for 2 seconds. The doors will lock-unlock once at a 1 second interval to inform the technician that the signal has been received from the transmitter. Close the drivers door, then open it. Press a transmitter button for 2 seconds. The doors will lock-unlock once at a 1 second interval to inform the technician that the signal has been received from the transmitter. If the doors lock-unlock once, the transmitter programming has been completed. Go to step 9 to continue programming for additional transmitters. If the doors lock-unlock twice, the transmitter programming is not complete. Go to step 9 to begin the transmitter programming again.
Reply to
Robert Hancock

replying to Robert Hancock, David Gardner wrote: Thank you. It was complicated, but your instructions were spot on.

Reply to
David Gardner

I get to the second remote and I get the two lock unlock cycles. Then I go back to step 9 and do it again for both remotes or only the second one?

I have not made it work yet, so not sure what is going wrong. snipped-for-privacy@usa.net

Reply to
lectroken

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.