General Motors Forum

  1. Home
  2. General Motors Forum
11153 Threads Posts
to

Worth reading in General Motors Forum

Help: 88 Cadillac ECM output overrides

1988 Cadillac Sedan DeVille, 4.5L Gentlemen, I am trying to test my EGR valve using the on board diagnostic capability...
2 comments posted 22yrs
posted by b
2 comments posted 22yrs posted by b

Replacing Turn Signal Switch - Hard Job ?

Anyone change one of these before on a 1991 Buick Regal that can offer me some insight or tricks that I might run into d...
0 comments posted 22yrs
posted by lecloony
0 comments posted 22yrs posted by lecloony

1966 Executive Starter question

I'm just getting back into the wonderful world of car restoration after about a 20 year layoff (ok, I wasn't that good...
7 comments posted 22yrs
posted by ceiboss1
7 comments posted 22yrs posted by ceiboss1

TH350 question

Will a TH350 upshift in it is in low like a TH400? If so, at about what RPM and what determines it? Al
1 comments posted 22yrs
posted by nospamsal1
1 comments posted 22yrs posted by nospamsal1

GM (AC Delco) Car Stereo Red Display Faded

I recently purchased a 2000 Pontiac Sunfire with a factory AM/FM/CD/Tape stereo that has a red LCD display. The display...
11 comments posted 22yrs
posted by dcmoose
11 comments posted 22yrs posted by dcmoose

Common 87 Camero Ignition Failure When Warm

Hi, My brother has a problem with his 1987 Chev Camero. When driving his car, after it warms up, the car will stall, an...
0 comments posted 22yrs
posted by bpetria
0 comments posted 22yrs posted by bpetria

Spedomoeter problem

1990 Chevy Corsica 2.2 L W/AC Automatic I just got my car back from the shop, replaced the computer and the head gasket...
1 comments posted 22yrs
posted by sthayer
1 comments posted 22yrs posted by sthayer

Re: Tough technical questions

> 1. The application is to install a rotary shaft oil seal in an aluminum > housing. The configuration of the seal is w...
8 comments posted 22yrs
posted by hairy411
8 comments posted 22yrs posted by hairy411

Rubber Floor Mats for Yukon?

Does anyone have a recommendation for a set of rubber floor mats? I'm looking for a set that has a lip to contain liquid...
6 comments posted 22yrs
posted by jdaviso1
6 comments posted 22yrs posted by jdaviso1

Lubricating Wiper Linkage

1990 Olds Silhouette Time to lubricate (and fix all the gremlins) in the wiper system. Some of the sockets look pretty...
0 comments posted 22yrs
posted by Peter
0 comments posted 22yrs posted by Peter

Anyone know of a U-Pull near West Texas?

Does anyone know of a U-Pull junk yard in the West Texas area? Thanks I appreciate it
18 comments posted 22yrs
posted by someone
18 comments posted 22yrs posted by someone

Antenna Won't Go Down

1993 Buick Regal. When I turn the radio off I can hear the motor trying to pull it back in. I cleaned the antenna with...
5 comments posted 22yrs
posted by wwhook
5 comments posted 22yrs posted by wwhook

Venture Luggage Rack

I have a 97 Venture, and after 7 years of struggling with the luggage rack bars that were installed backwards from the...
0 comments posted 22yrs
posted by Kevin
0 comments posted 22yrs posted by Kevin