i have removed the axels but i still have trouble with clearence because i cant get the block past the transmission becauseof the flyweel and pressure plate ect. and i cant remove the pullies because i cant get them of i even tried to remove it stright throw the bottom but i cant go any further down because of the engine mount and i cant take it of with out removing the pully because it is behind that stupid cover do you have any other suggestions that i might be able to try.
Re: Removing Engine
Apr 21, 2006
1 Replies
Normally engines and transmissions are removed as an assembly. It sounds like the bell housing is preventing you from moving the engine to where it will come out. With the two connected, the tilt bar Eric refers to should allow the engine to come out with the tranny tilted down.
Mike
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required