As I work though my electrical issues I found a big void in the fuse panel.
On the top of the panel above the fuses are 2 large grey plug-ins (circuit breakers)
Any way I am missing the right one labled T/S.
Thanks AGAIN!
Ross
86 CJ 7 258As I work though my electrical issues I found a big void in the fuse panel.
On the top of the panel above the fuses are 2 large grey plug-ins (circuit breakers)
Any way I am missing the right one labled T/S.
Thanks AGAIN!
Ross
86 CJ 7 258Ok......
I think you might have more issues with the turn signals than you think seeing as that 'should' be the Turn Signal flasher in there.....
The other one is for the hazard lights.
Just a FYI, the Haynes CJ manual has a wiring schematic that is right on for them and is an inexpensive book.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT'sJack-Jack wrote:
Ok then so my NONE of my turn signals should work without that?
What is that called so I can replace it...I have the Haynes that how I figured it was missing.
It is a basic turn signal flasher unit. They even sell loud ones so in theory you can hear it when the sun shines on the dash and you can't see the lights.
Only the hazard lights 'should' be working without it....
You can swap the hazard flasher over to the signal one's socket for testing purposes.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT'sJack-Jack wrote:
I did the swap and the status of the signals did not change although the fit in the turnsignal side was very loose where on the hazard side it "clicks" in.
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.