Hi
Just done a swivel housing replacement and the ASB light stays on, checked the resistance of the sensor, 970 ohms, same as the other side not touched. I reset the sensor as per manual but the light still stays lit and doesn't flash at switch on. Any ideas other than paying £50 to put it on a testbook??
Peter S
Peter, I had exactly this problem, the test book indicated that the sensor was only operating correctly about about 10mph, I spent months b*ggering about with it. (Replaced sensors, relays and all sorts) Eventually I checked with the insurance company and stripped the ABS system off completely and fitted a servo/master. Good luck. Cheers, Sam
Peter Sedd> Hi
Thanks for that but after a bit of reading (RTFM) I set the gap as per, and the problem went away.
Peter S
Wow! lucky you, I spent ages re-gapping the damned thing..... never got anywhere. Well done that man, you suceeded where many before (including me) lesser men have failed. Cheers, Sam
Peter Sedd> Thanks for that but after a bit of reading (RTFM) I set the gap as per, and
On or around Sat, 04 Oct 2003 21:18:03 +0100, Sam Clayton enlightened us thusly:
got a broken sensor on the 4x4 Sierra. it was stuck in it's mounting hole, and I needed the hub carrier off to change the wheelbearing. knocked sensor from hole most carefully, but now it don't work. No facility on this one for gap-setting, so it ain't that. Brakes still work, however...
Have something to add? Share your thoughts — no account required.
Ask the community — no account required