My significant other is fed up with getting wet feet. I've therefore decided to sort out the leaking (I assume) bulkhead vent seal. I've just removed it and it's covered in glue in various places which I have cleaned off.
I'm intending to re-use it as it's in good condition. Which face(s) of the seal should the adhesive be applied to as it not obvious from the 'pattern' of adhesive on the removed seal?
Regards
Richard
The glue goes on the coarser side.
Richard
Thanks for the info Richard. I'll have a look for a bit of rough!
Richard
In news:56e2a0d64d% snipped-for-privacy@btconnect.com, beamendsltd blithered:
Of course it does.
If you wish to avoid disappointment on re-assembly check that the linkage is actually closing the ventilator flap properly.
The vent was a little 'un-straight' so I've tapped it a bit to correct that. I'll check it closes properly when I sort it out in the morning.
Thanks for the advice.
Richard
Wellies !
Have something to add? Share your thoughts — no account required.
Ask the community — no account required