Hi all,
Got my new rear air springs from Brookwells this morning, with the aim of fitting them before I drive up to Leeds this afternoon. Nyahahahahaha...
This tutorial:
formatting link
half an hour to do the job. It's been an hour so far and I've notactually achieved anything at all, apart from to bend the retaining clips. How do you get the flaming clips out? I've tried pushing (with a hammer and screwdriver) and pulling (with pliers) but both actions seem more intent on bending the clip than actually moving it at all.And once I've got the bottom clips out, how on earth do I get to the top part of the spring without taking the wheel arch liner out? I can't even
*see* the top of the spring, let alone do anything with it.
If anybody can shed any light, I'd be very grateful, but I think I'll be driving to Leeds on the old springs at this rate.
Thanks, David.