1998 Hyundai Coupe FX (Tiburon) warm start problem

Nov 16, 2003 8 Replies

Hi



I have a 1998 Hyundai Coupe FX (Tiburon) with a warm start problem, when the car has reached operating temperature, if it is switched off, it will not restart until it has cooled down.



It's the 1.6 engine version.



This problem began happening a few weeks ago, but is really only noticable on multiple short journeys. On the road, it seems to run fine, although the idle is a little rough & it stumbles at idle sometimes.



Today, I let it warm up & noticed during the warm up phase, at one point it appeared to stumble, almost cut out, then recovered, then carried on as normal. When I switched it off, then on, it would not fire up.



Cranking is fine, but there are no sparks at the plugs.



The coil seems OK, resistance wise, the plugs were changed recently.I suspect some defective sensor is preventing the ECU from driving the coil.



I had a look at the Hyundai tech pages, nothing exactly like this problem, although they do say the crank sensor might be a reason for a no start condition. The camshaft sensor is also a potential failure point.



A Google search turned up lots of starting problems, but nothing related to temperature.



The car starts first time from cold, every time. Has anybody seen anything like this before?



Which sensor is not critical, as one seems to cut out when hot, but the engine runs anyway?



Where exactly is the ECM (ECU)located?



Thanks



Gerryo


exactly the same problem with my 1998 Accent!

It's going to the Hyundai dealers today, I'll post the results when available.

Gerryo

I'm looking forward to finding out! thanks

I had exactly the same problem on my son's '94 Scoupe with the 1.5 engine. The coolant temperature sensor was bad.

This was located in the thermostat housing. There were 2 sensors mounted there. The coolant sensor was the lower of the two.

The car can't sense the engine is warmed up and is basically flooding the engine with too much gas.

in this case, did the computer store a trouble code? and did you smell gas when this was happening?

Yes. That's how I tracked it down. I don't remember any unusual gas smell.

Got the car back this evening, it was the crank sensor.

Job cost Euro 177 ( approx. $210 or £124). Sensor cost was Euro 74 (approx. $88 or £52).

Interesting reading on the garage report, there were no fault codes revealed by the diagnostics, nothing stored in the ECU.

However, the following is from the Hyundai diagnostic trouble code list...

Code Problem P0335 Crankshaft position sensor circuit malfunction Crankshaft Position Sensor P0336 Crankshaft position sensor circuit range Wonder why none of these was stored, seems like it should have been P0335 at least.

Gerryo

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required