I am going to be pulling the power steering cylinder off my 67 mustang this next week for a rebuild due to it leaking. Wondering if there are any things to watch out for or if it is pretty much straightforward. Any step-by-step process to make it easy as possible?
Thanks
its pretty straight forward. use care in removing. check push rod for straightness. Check the rod for pits and corrosion, this can tear up new seals. Clean up the threads before reinstalling. Use new bushings for the ram end. the inner boot and clamp(where it attaches to the center link) are not usually part of the rebuild kit, so be sure and order them also. Mark the short hose locations on the ram, most common mistake here is crossing the hoses when reinstalling (they tend to fit better or lay closer when hooked up backwards)
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.