2000 406 hdi car wouldnt startbut after turning engine over 4 about 30 seconds would start.this went on 4 about a week,now car wont start at all. had car diagnosed at local garage and they said the high presure pump was at fault, so had that changed car now starts up straight away but stalls after 10 seconds some times will run 4 30 seconds. car starts up straight away each time have. have changed the fuel relay by the ecu also since the new pump has been fitted if u turn the car of when its running it doesnt stop until the key is taken out has any 1 got any ideas. have also changed the camshaft sensor. when u plug it into the computor it says fuel rail pressure have also changed fuel rail sensor, i need help
non starting 406 hdi
Jul 12, 2005
4 Replies
Sorry to hear about your ordeal , my advice take it to a main dealer perhaps goodfellowsgarage walsall west mids if you are local to that area .yes main dealers can be expensive ,but this is a good example that its better to pay one bill of a said amount than x20 £50 from fred from the shed.. all the best mark
It sound as if the lift pump in the tank might be causing problems. I agree with Mark B that you need to get it properly diagnosed.
i'd rather look at the stop solenoid,
I agree
diag 2000 is one way to go....
It hasn't got a stop solenoid mate its h.d.i remember!.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required