94 grand am - auto trans noisy when in DRIVE

The engine in this car threw a rod and locked the engine. After replacing the engine, the transmission makes a groaning noise while in forward gear, even when not moving. Sounds okay in Park, Rev, Neutral. The sound is almost like a bare brake shoe grinding on a scored rotor. It's not the brakes or CV joint. It makes noise while sitting still.

The car will move...its been down the street about 500 feet and back since the engine was replaced. I'm afraid to run it since it may cause more damage.

Any ideas what can get damaged with a sudden stop when an engine locks? Other reasons?

Reply to
Larry Ruch
Loading thread data ...

Transmissions can have so many different failures, we have no way of telling what happened until you open it up. Check your fluid level, and COLOR of the fluid and get back to us.

Reply to
TANYA LAWSON

Fluid level is good. Color was dark but still red-ish. I replaced the filter and fluid-just in case. The sound is still there. A friend said it may be a stretched chain that connects to the input shaft behind the TC. I'm dropping it out tomorrow. We'll see. The transmission is a 4T60E.

Reply to
Larry Ruch

I have the ATSG manual for that transmission. When you drop it, start at the passenger side of the transmission and pull the differential cover off first. Just a couple of bolts. Look at the differential. If it looks ok then put the cover back on. Then you can start at the drivers side and pull the side cover off. If you want, need any specific information, email me and I can help you through this. My 4T60E is sitting on my work bench in my basement right now. Just awaiting $45 gaskets. THATS just 2 that I need. I also have a boat load of pictures of this transmission torn apart also for reference. Mike

Reply to
TANYA LAWSON

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.