1. Home
  2. Saturn Cars Forum
  3. 1998 SW2 clunking noise from front suspension?

1998 SW2 clunking noise from front suspension?

Looking for a bit of help. I have a 1998 SW2 that I have had since new. It has about 125,000 miles on it and still going strong. Just recently it started developing a occasional 'bangy' clunk when turning.

I was thinking CV joint but I think that would be more than one clunk (it would be more of a series of clunks). Driveability is totally unfazed. It seems to be coming from the wheel well areas but I can't localize it.

I had the car in for a check-up about 6 months ago and they replaced the Tie rod ends and the right lower control arm. They have always done exceptional work so I doubt it's related.

Thoughts, suggestions?

I'm wondering about the sawybar bushings at this point.

Richard

Reply to
Poptart
Loading thread data ...

Sway bar rubber components may possibly be worn and hitting as you said. Engine mounts? Broken spring, strut top mount or strut?

Is the noise from the front or rear?

Reply to
Oppie

Thanks,

I thought about the engine mounts, but it's a standard and I thought that I would notice the clunk when engaging the clunk but I don't.

The noise is entirely from the front. I wondered about the strut top, but I thought I would get wind-up (the corner would rise) if the plate was seized? There's not any perceivable shudder to go with the bang/clunk and it only occurs at low speeds with big steering inputs.

Richard

Reply to
Poptart

1- Jack up both front wheels, and place on SECURE blocking. 2- Do a complete inspection.

This may also be a good time to rotate your tires, and check / replace your front brake pads and rotors if required.

Good luck, YMMV

Reply to
Private

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.