2002 S10. MIL has gone on/off a few times. Bought a cheap code reader. With light on it had a p0137 and a pending p0137 (bank1 sensor2 oxygen sensor lean condition). Manual says MIl will go off after 3 ignition cycles that the P0137 test passes. MIL has now gone off, but the reader still shows the same codes. There is something in the manual about 40 ignition cycles. Is that what's required for the codes to disappear? My reader won't just clear the codes, apparently it resets the whole I/M testing status. Thanks
s10 obd2 operation
Jan 26, 2009
2 Replies
You need to check the sensor using a better scanner. The original code has cleared the three cycle limit and turned off the light. The pending event of the same code means it has detected the SAME fault again and will turn on the light the next time it sees it. You can clear the codes and look at the voltage from that sensor with a better unit.
Any exhaust leaks on that side or bad gasket? Either one could cause this code. Could also be a bad sensor. Without seeing it's actual voltage output you won't be able to tell.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required