I test drove a 03 vette last night with a supercharger. At low idle it would keep changing from about 800 RPM to 1300RPM. Up and down. I was this is normal for any supercharged engine. Is this normal, or there something wrong?
There was also a fuel/mixture control. Can anyone explain how to set this?
Thanks, Andy
Didn't find your answer? Ask the community — no account required.
J
John S.
I don't believe the Corvette came with a supercharger, so this is something the last owner added and the car may or may not comply with emissions standards in your state. Surging idle isn't normal and may be indicative of an easily solved problem or botched supercharger installation or something else.
If you are interested in the car I would get it thoroughly checked out by a mechanic who is familiar with vettes.
R
ray
it might be normal for that install, but it's not normal for a properly set up supercharger install. All those Pontiac Bonnevilles with the 'charged 3.8 idle pretty tamely.
And no stock 03 Vette comes supercharged, so I'd consider getting an independent mechanic assess the install and the rest of the powertrain... the stock LS1 clutches don't hold up to power adders that well, and well... if it's been raced, it should be priced accordingly.
There's nothing wrong with a modified car - I have nitrous on my Trans Am, but buying a used modified car is always a bit of a crapshoot... is this engine #2, transmission #4 and rearend #3 because parts keep breaking? Or does it overheat all the time and fail emissions testing? Why is it being sold?
The fuel mixture control is probably part of the SC kit - what does the owner say about this?
Ray
B
Bruce Chang
The surging idle is not something to just glance over. I have a supercharger on my 89 Trans Am and the idle is steady. There is definitely something wrong. Probably a vacuum leak possibly caused by going into boost and blowing a vacuum line off that couldn't handle the added pressure.
The fuel/mixture control is meant to keep the air/fuel ratio rich when you go into boost. If you lean the mixture out too much, you will burn a valve and you'll experience more problems than you already have. To set it, you need to know a lot of information you'll probably never get. Typically one would overly richen the mixture and slowly work down from there until the air/fuel ratio gauge shows the mixture registers on the scale instead of so rich, it's off the scale.
A
andysabol
thanks. There was a lot of changes here. In fact, too many
Andy
A
andysabol
Hi,
I also thought something was wrong. The dealer said it was normal for a supercharger. And the fuel mixture scares me. Sounds too easy to blow the engine.
Thanks, Andy
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required
Report Content
You are reporting this content to the moderators. They will look at it
ASAP.