96 Signal lights flashing after ignition turned off

Vehicle: 1996 4Runner, SR5 V6, 5 speed manual

Problem: Signal and dash lights flash and chime sounds after turning off ignition and removing key.

Help

Reply to
Jurgen
Loading thread data ...

Hi some things to check. Ensure that the hazard switch isn't sticking on, (operate harshly to unstick works sometimes) An alarm fault. A bad earthing point.

Joe

Reply to
Joe

Thanks for replying. The hazard switch is fine - the lights only flash after the engine is off and the key has been removed... However, the aftermarket alarm system, that's had its power disconnected for some time, may be the culprit - my weekend project to clean it up...

Jurgen

Reply to
Jurgen

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.