Combination Switch 1999 concord

Remove old switch, install new switch. Oh - wait - that's the Haynes/Chiltons manual version!

Seriously - It's not as daunting as you might think. You'll need a couple of different sizes of torx drivers (one for removing steering wheel tilt lever and one for removing two screws attaching lower column shroud). You will need to raise and lower the steering wheel at certain points to get the upper and lower shrouds off - it will be obvious which to do when.

Upper shroud unlatches from lower shroud by squeezing inward towards the front of the shrouds at the joint between upper and lower shrouds - upper shroud lifts up. Remove tilt lever (1 screw). Remove lower shroud (two screws from underneath). Remove two screws attaching switch. Unhook wiring from the retaining hooks and remove connector from switch.

Bill Putney (To reply by e-mail, replace the last letter of the alphabet in my address with the letter 'x')