1996 Ford Contour GL 2.0 Engine Stalls

Jan 05, 2006 3 Replies

I have replaced the fuel pump, timing belt, mass airflow sensor and repaired the fuel injector wires that were bear and touching for this vehicle. It runs fine and idle in park but after you put it in drive, it shakes and cuts off after 4 to 5 minutes. Any suggestions?



Idle Air Control Valve. It's very common.

CJB

Thanks. They said they checked the Idle Air Control Valve and it is ok. Could there be anything else causing this problem?

The "4 to 5 minutes" part is interesting. Have you checked the fuel pressure at the exact time when the car quits? Perhaps you have a bad pressure regulator or even a wiring connection to the fuel pump that becomes open when hot.

CJB

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required