1991 jeep cherokee inline 6

Feb 02, 2005 2 Replies
R

greetings, we've had the check engine light come on for some time now but only while running for about 15mins. finally bought a odb tool and plugged her up and here's what came out. was wondering if someone can give us some directions on fixing the cause of the codes. TIA


1) 33 Open/Short detected in A/C clutch relay (the car has no A/C)


2) 35 Open/Short detected in radiator relay i assume just to replace the switch. can someone let me know where this is located and if there are any special tools/method required to retrieve it?


51 Sustain lean air/fuel ratio condition detect in 02 sensor bank 1 position 1.

i assume just to replace the o2 sensor. can someone let me know where this is located and if there are any special tools/method required to retrieve it? also, are there more then 02 sensor on the car?



thanks!



Vote
Twitter Facebook LinkedIn
J

Follow the exhaust manifold from the block to the bumper. When you find something with wires in it, you have found the O2 Sensor. It unscrews like a spark plug.

Clear all of the other codes, and check again in a week or so.

Vote
Twitter Facebook LinkedIn
M

I would fix the rad relay first and see if that changes the computer to run not lean. The computer is supposed to switch from rich to lean according to the temperature. If it doesn't see the signal correctly, it can stay either lean or rich not switching setting code 35. Fixing that might make code 51 go away.

Mike

86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's

snipped-for-privacy@yahoo.com wrote:

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required