Hi,
I need to remove a spacer gear on an AX-5 transmission that is located on the counter shaft next to the fifth gear. It looks to be the final thing I need to remove to disassemble the gearbox with the intentions of doing a full sync ring job.
This spacer appears to be put on a spline and is possibly cast too. There is no room to get a regular bearing puller in there. Has anyone done a transmission repair like this is my most basic question. Thanks!
Fabe CBS, NL Canada
I feel a bit upset about people tagging you. A person tries to help out and they find everything wrong you. Been there.
I have visited your web page and just find you are a good family man. If you want to get into facts, I could not get that manual for that AX-5. The dealer would not even let me look at it. The nearest I could come was from EBay with the Auzzies. That shipping would have cost a human liver.
I am presently trying to get the body mounts off that old '93 YJ rig. The mainframe is gone and I want to stick in a brace. I am contemplating, I should jack the body for a counter force? The AX-5 sits at my feet. This looks busy. The machine shop up the road were stunned and put the main shaft in a vise to get at the 5th spacer. I guess I was not paying attention because they might have harmed it.
Whatever Bill.. fools are like ants. Too many, too fast.
Fabe
P.S. I am still an electrical engineer. If I can help out, just email me.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required