Ok, heres a really simple thing thats got me beat!
The bonet catch on my 90 will shut OK if i drop it from about 6 - 8 inches, problem is getting the bloody thing open again!
I have removed the sliding catch mechanism, cleaned and re greased, cable pull mechanism seems to work fine.
The problem appears to be when the bonet comes down the locating pin is about 3 - 4mm too far forward and there appears to be no adjustment in this direction for the catch. Screwing the bonet pin in (shortening it) doesnt seem to help either.
Are the locating pins cast steel ? I have hit it a few times to bend it backwards but am reluctant to hit too hard incase it shears off! the alternative is to slot the catch / body to move the whole thing forward.
Anything I'm missing / expert tips to make it fit!
Thanks Jon