Hi all, with reference to Range Rover's ( Classic's ) there are two different shaped axle cases:- round with drain plug at bottom, and flat bottomed with drain to one side, what other differences are there between these ratios suspension points ect:-
Rich
Not a lot, the flat bottomed one is the later one and it may coincide with the addition of an extra bolt (seven in all) holding the swivel housing to the axle casing on each side, also to the addition of anti-roll bar fittings. Ratios of the diffs and suspension points are all the same I think.
Martin
Would the diffs be interchangeable and is this the point they changed the splines on the half shafts ?
Rich
The diffs are the same.
I'd be guessing on the splines but you could always change the halfshafts as well I suppose.
Martin
Ok thanks for the replies
Rich
Have something to add? Share your thoughts — no account required.
Ask the community — no account required