James
I have got the official fitting instruction for this unit - or at least the one used on the Series IIA.
I can't remember the detail so will have to read up on it. This may now be after Christmas. I'll do you an Acrobat copy.
Your e-mail address looks as though it will work. Let me know if I should send it somewhere else.
David
Hi
I made a mistake and did not take note of the oil cooler piping from the filter housing on my ser III 2,25 petrol during my engine removal. Can anyone tell me whether the fitting from the adaptor between oil filter and engine block should face up or down. (can go both ways) This fitting joins to the pipe feeding the oil cooler. Also : I noticed when I opened my oil pump, that the relief valve ball was missing so I fitted a new ball from an old bearing. Have much better oil pressure but I later read in the Haynes book that when a oil cooler is fitted to the system, a new plunger and spring are supplied to fit the relief valve in oil pump. There is no mention of the ball however. Can anyone spread a little light on the matter please.
Cheers James
The pars book shows it pointing down.
There's no mention of this in the parts book, perhaps they are really meaning one of the two relief valves included in the oil cooler kit? Just a thought...
Cheers Richard
I will be assembling tonight (South Africa Time) so I would prefer to know before then, Thanks anyways. James
PS. If the file is large you could rather send to jamesw at pescanova dot co dot za
I'm sending two files to your other address. Done in a rush you'll have to work it out yourself!
Good luck
jamsan wrote:
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.