Hi all
I have a 1988 3.5 efi RR and one of the fuel injectors is not working ( all the ignition checks out). I have swapped the leads over between the dodgy one and its neighbour and in actual fact it checks out as OK with the fault transferred to its neighbour, so the problem is in the wiring, the injector is not receiving its signal.
My question is, is there a connector block i can check out or do the leads run straight thru' to the CPU ? I am assuming it is not the CPU as i believe the signals to the injectors are a bank of four at a time, so that problem would be obvious. Am I on the right lines with this, has anyone else had a similar problem?
I am hoping it it just a bad connector somewhere, but were should i start looking?
Any kelp appreciated
Cheers
John