The wires from the sensors on the rear bumper have to be passed from outside the car to the inside. Can anyone offer advice on what is a good place to do this - is there a ready made hole that can be used? Or if I have to drill, where would be a good place to do so?
Also, the feed wire to the sensor control box has to be connected to the wire that feeds the reversing lights. Where would be a good place to tap onto this reversing light feed?
Regards.
Bumper has to be drilled. Put a bit of masking tape over the area to avoid drill skidding. Open up the holes with rat tail file to make tight fit for the sensors. Feed cables through from the outside. If there isn't an access hole into the boot space you have to drill one. Fit a rubber grommet to avoid chafing the wires. Hide the cables under the boot trim and connect to reverse lamp power connector. DaveK.
Thank you for your response. Al.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required