The stream of fluid from one of my windshield washer jets is weak (e.g., doesn't make it above the wiper). I think the problem is the little valve in the hose that feeds the jet (e.g., when I switch the valves from one side to the other, the weak stream changes sides). Problem is the dealer want $19.80 each for these little valves. Any ideas for an alternate source or other solution?
Thanks,
Gus (91 BRG)
DON'T PAY IT!
They are very simple to remove (I believe you squeeze in on two lil prongs on the underside of the hood and they pop right out) You need to clean them out (mineral deposits and just general garbage that has accumulated) this can be done with a straight pin. Poke and poke and scrape and blow through both directions till you get them re-opened properly.
Chris
92BB&TEven though I had cleaned them out before I tried it again (this time using Simple Green) and I now have a strong stream on both sides. Note that the problem was with the non-return valve not the spray jet on the hood. The non-return valves are easy to remove.
Gus (91 BRG)
Have something to add? Share your thoughts — no account required.
Ask the community — no account required