OT: Ebayer not shipping my Purchase....

May 05, 2004 25 Replies

The gif image is that of my 97 5.0 coupe. webeproducts is my manufacturer, no matter which site you order from (or Ebay under webeproducts) you will get the same great quality kit. Lawrence (owner/manufacturer) is a master at electronics

Through our arrangement, I simply advertise/promote his product now but am heavily involved with the R&D of new products. I obviously back his products

110% or I would not offer them.

It was right here quite a few years ago we held a group purchase upon the rollout of the sequential turnsignals. Others have manufactured them too but WE perfected them into one of the easiest,best made kits available hands down !!!!!!! We have just released a convertible styling bar/light bar module which will turn the bars LED light on or off automatically depending upon convertible top position (either up or down) and also has the ability to alternate between the bars light and the trunk mounted light.

TIM -aka- MUSTTANGUY "at" AOL "dot" COM

formatting link

Any chance of coming up with an LED replacement for the 1157's used originally in my 66's taillights? I've seen the kit that replaces the 1157's with sequential LED's. The reason I ask is because the LED's are brighter and don't put out any heat. I don't want be replacing melted lenses continuously.

I've been thinkin Paul... there must be a way.. think about it, ours cound go from top to bottom rather than inside to outside. No THAT would be different! I think it would look hella cool!

All I have to do is figure out how to make that bottom reflector lens a light lens too and I'd have it made. I had it about figured out once and got sidetracked on another project and forgot about it till now. Should be pretty easy, 98 style harness, drill and file the holse to fit the third light socket... time and patience my friend...

Right after I get everything else done around here.

Kate

at 08 May 2004, SVTKate [ snipped-for-privacy@excite.competitive] wrote in news:NV4nc.9280$ snipped-for-privacy@newsread2.news.atl.earthlink.net:

Definately way cool and bound to catch attention. Even from those not paying any normally. So they'll notice we be about to turn. :-)

Either that, or cycle it just on the two top ones, getting a flip/flop effect like some schoolbuses around here. I agree with you tho, it should be doable without to many problems. Either or find a way to replace the bulbs with led units for less electricity consumption and more brightness. I just don't want to have to rip most of the trunk apart to get at one of these units to see if it would be possible to insert a circuitboard with a whole bunch of LED's in there in place of the lighbulbs. Depends if one can get the lenscover off and if then there is enough room. That way, we could even do sequentials that go from inside to outside using eg a 3rd of the width of the lens.

It is. He was delaying shipping my item for NO legal reason.

(BTW, the item was a Wilwood adjustable proportioning valve that I needed for my TC rear-end upgrade.)

I bought his item via the "Buy Now" option in order to have it to me within a week. I ended up writing him a fairly stern note about the legal aspects of what he was doing, and he ended up shipping my part the next day.

The guy has a 157 Feedbacks with 98% Positives. If he would have entered his little Policy in his Auction in the first place, I would NOT have bought it.

-ERIC

I'm not leaving him ANY Feedback unless he leaves one on me. I'm the Buyer in this Auction and fulfilled my commitment with in (2) minutes of buying the item via "Buy Now".

-ERIC

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required