how do you replace the center console light bulb on the gear selector on a
2001 Pontiac Sunfire?- posted
18 years ago
how do you replace the center console light bulb on the gear selector on a
2001 Pontiac Sunfire?The service manual says that you have to remove the console to get at the bulb. Here's the procedure:
Document ID# 739277
2001 Pontiac Sunfire-------------------------------------------------------------------------------- Console Replacement - Front Floor
Removal Procedure On vehicles with manual transmission, release the snaps on the shift boot. Using a small flat-bladed tool, remove the front screw cover [Note from SS: this is a round plastic cover].
Using a small flat-bladed tool, remove the center storage pocket, if equipped. Remove the power window switch plate, if equipped. Refer to Power Window Switch Replacement in Doors. Raise the armrest (1) from the front floor console. Remove the bolts (6) from the front floor console. Remove the front floor console by lifting up and back. Guide the shift boot over the optional shift knob and over the emergency brake handle.
Installation Procedure
Install the front floor console by guiding the shift boot over the optional shift knob and over the emergency brake handle.
Notice Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Install the bolts (6) to the front floor console. Tighten Tighten the bolts to 6 N·m (53 lb in). Lower the armrest (1). Install the optional center storage pocket. Press into place until fully seated. Install the optional power window switch plate. Refer to Power Window Switch Replacement in Doors. Install the front screw cover. Press into place until fully seated. On vehicles with manual transmission, attach the snaps on the shift boot.
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.