Can anyone supply ecu flash codes for a rover 216 with the honda pgm fi unit. My engine check light comes on after about 15 minutes travelling, The car still functions ok but the idle is a bit rough.I also want to reset this ecu as i think it is showing more than one code. I have pulled the fuse for this (by the drivers right knee)for about 30 minutes but it did not clear it Thanks Gary
E.C.U Flash codes Rover 216 (1993) Honda engine
Jul 29, 2003
3 Replies
According to my Haynes manual you reset the ECU by removing the 10Amp fuse in the engine compartment fuse box. It mentions an ECU fuse in the driver compartment in a list a the back of the book, but the written section on resetting mentions the 10amp hazard warning one in the engine compart.
Yes I pulled the hazzard fuse and this reset the ecu (there were no flashes at all) upon restarting the car it would not idle, I had to increase the tick over speed
message
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required