NO AC after PCM flash on 2000 SL2

Hello,

Today I took my 2000 SL2 to the dealer to have the PCM flashed. I had added factory cruise control components, but the car didn't recognise it. I have been told by several people that just flashing the PCM would solve this.

Well, when I took my car into the dealer everything was working except for the cruise I had added.

They came out and told me they upgraded the PCM to the latest code that had a bunch of improvements. Well, then they returned my car, but asked me if the airbag light had been on. I told them yes, but only when I had been running the car with no airbag connected. Once I put the airbag module back on, there was no airbag light. Then they told me they would have to dive in and do more diagnostics (well at $91 an hour, I wasn't up for that) so I told them I would take th car.

Then I got going down the road and I noticed that the AC would not come on. I turned around and went back to the dealer and asked if there was any reason the AC should not come on. Well the service forman jumped in the car and took it back into the shop. After an hour they came out and told me they didn't have time to look at my car right now, but they would spend some more time with it later if I could leave it with them.

At the end of the day, they called me and said they had spent 3-4 hours on my car, that they were not going to charge me for, but to do any further diagnostics, they would have to charge me for 2 hours $182. UUGH. Now I am wondering if I should just buy a used PCM.

Does anyone have any other suggestions?

Is the BCM involved with the AC and Cruise Control at all, or should I just concentrate on the PCM?

Please reply here and e-mail me if possible....

snipped-for-privacy@cbn.net.id

Reply to
millerk
Loading thread data ...

snip

Assuming you didn't knock something off when you installed the Cruise Control::

You brought a car into the dealer with a working A/C system.

You left with a non functioning A/C system.

You should not have to pay for this repair unless they can prove to you that some unrelated part, like the compressor, just happened to fail at that time.

Before you bring it in, I would check the connector on the low pressure switch for the A/C to make certain it didn't get knocked off. I'm not sure where it is in that car, but in most GM cars it is on the drier assembly.

Reply to
dirtbag

I had almost forgotten why I go through the skinned knuckles, smashed fingers and general discomfort from unnatural positions... the heat, dust, foaming vile liquids and yucky black grease that wont come off your hands, arms and elbows... the toil, the out and out strain (mental included) of a tough and frustrating mechanical challenge... .

Thanks for reminding me...

-WaVy

(currently accept>

Reply to
wavy

Well said.

Reply to
Private

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.