...that's really smart - it hadn't even occurred to me (I was dreading pulling everything apart). I'll double-check the line too - thanks!
I don't think the brakeline should touch anything but it's holders and > fittings.
>
> Disconnect the anti-sway-bar ends lube the bar next to the bushings, same
> side of each bushing, twist the bar end up & down while pushing the bar side
> to side in the car. May need to loosen the bushing clamps. Reconnect bar
> ends, and tighten clamps if needed. This way not everything needs to come
> apart. I hope this is of some help.
>
>
>
> > re: 97SL2
> >
> > Is the solid, bentline rear brake line supposed to ride against the > sway-bar
> > up in the channel that runs from each side of the car, or is there > supposed
> > to be some space?
> >
> > Also, I have urethane bushings on the bar - I hate the squeak and the > grease
> > I have looks like I have to take everything apart to lube the bushings - > any
> > suggestions?
> >
> >
>
>