I have a 1997 Legacy Outback, japanse buildt. This has a original infrared keyless entry system. Unfortunately I do not have the remote and the cost of buying a new one is to high compared to the limited range of a infrared controll.
I have bought a Enforcer SLI-830 keyless system which I wish to install. Does anyone have a clue which wiries to tap into in order to get this to work? This will probably be the same wiries as used to connect a aftermarket alarm.
I have located the keyless control module on the left side of the car. Taping into the drivers door switch will probably do no good since the door switch only controls all doors except the drivers door....
Any suggestions?