So here is my problem. In the past year, my cooling system has fell apart. The truck has a regular (not Vortec) 350 engine and so far, I myself have replace the radiator, hoses, thermostat, and waterpump.
The coolant level was holding constant until I recently had to begin using my heat intermittently. For the last month, I have been going through about a gallon of antifreeze a week. I have not been able to see any drips on the pavement when I park so I was puzzled. Today, I stopped somewhere and left the truck running and when i looked under it, the antifreeze was pooling out. I reached in and cut off my heat and the drips subsided. There was also antifreeze all over the driver side top of the motor between the throttle body and the valve cover. The rear passenger side of the engine was wet as well. All the fluids were dripping off the back side of the motor. All heater hoses are behind the motor as well, ( I believe). Just wondering what could cause the top of the motor to be wet if my thermostat seal and water pump are fine. The engine has been running fine and has not been missing or lost any power.
I'm just looking for any advice or suggestions. Thanks