hello any everyone i am looking for help on how to bleed ABS brake system on
I had to change the calipers and roters and in doing so i lost fluid, i re added fluids and bled the brakes but not much happened only later on i realised it was an ABS system and could not find the info on process to bleed it, please is anyone has words of wisdom or some help it would be greatly appreciated.
Thank You.
The ABS system's hydros are seperated from the service brakes until the ABS is activated...procedure is the same assuming no ABS cycling...
Try a gravity bleed, take the cap off and remove the bleeders, and keep filling the res until no air at the bleeders, then put them back in and bleed normally. Sometimes it takes some time and a wide open exit to get the calipers to fill completely...you can tap them gently too, to dislodge any air pockets that might be clinging to inside surfaces...
Have something to add? Share your thoughts — no account required.
Ask the community — no account required