belt tightening

Not a picture but a short description:

• remove the generator nut and spacer with 21 mm wrench and=20 a screwdriver (place the screwdriver to the slot in the front part=20 of the generator pulley to hold the pulley and axle in place)

• take out the nut and possible shims under them

• take out the rear part of the pulley

• take 1 or 2 shims out from between the pulley halves

• put back the rear part of the pulley

• insert the shims that were there + the shims you took out from between the pulley halves behind the pulley

• put the spacer and the nut back and tighten the nut rotating the pulley time to time back and forth to make the belt to raise properly on the pulley