wanted, 71 ghia AND 'oldie' VW beetle parts, n florida/south georgia?

Feb 13, 2004 0 Replies
1971 (used and/OR new) GHIA PARTS NEEDED, will pay fair cash value & bring tools if I need to (car vin# 141293014). would like to pick up in person, hopefully, some (or better yet ALL?) the following: gas tank, ghia (mine's totally unuseable, completely shot) -note: some beetle tanks of similar year 'will fit the ghia with minor alteration to filler neck'-or so I've read. anybody know what that 'minor alteration' -is- exactly?

tires, @ least THREE: 165/80-SR-15 or similar, used, whatever. also eight spoke EMPI rims? caliper or rebuild kits, front disc brake??? & NEW brake caliper "locktabs" (sheet metal, 2 holes ea)



four "flex" rubber brake lines (one@eachwheel, new only) front hoses 311 611 701B (B suffix may be error) rear hoses 113 611 775E (E suffix may be error)



brake pedal return spring #131 721 163 (@pedal assy 'center')



'early beetle' glass-covered headlight assemblies, complete, both sides, for 'grafting onto' front of ghia, hopefully with nearby/surrounding sheetmetal, =OR= GHIA headlite area ?buckets' and exterior patch panels, both sides



carpet pieces, ghia TAN, original, one 'foot vent cover'(slightly wavy, roughly 5" x 22", & one rear floor piece (pass side), & the BIG 'front piece' that goes UNDER the black rubber front floormat (carpet pieces: filthy, dirty/stained OK, worn thru or ripped=not OK)



brake pedal 'horseshoe clip with an eyebrow', @heart of pedal ass'y, @pin on brake pedal



one piece side trim@rear (goes immediately in front of rear wheel) plus need ALL new side trim fastening "buttons" (anybody know who sells these _without_ buying a side trim 'kit'?)-I already have all the sidetrim, less one piece...



2 hubcaps, used, IF unscratched (minor dents OK, some interior rust OK, but NO 'rust perforations") ?clutch adjuster' wing nut

rear engine lid IF with NO (or minor) dings/NO (or very little) rust



tranny input pilot shaft seal, GOOD one oil filler cap GASKET #111 115 487 oil pump studs, four "normal" length



six 'wave type' lock washers, for under pressure plate boltheads



"Cool tin", used OK...



engine compartment sheet metal, 2 pieces (large crosspieces@front & rear) withOUT "autostickshift tube" holes



door check ?straps' or 'rollers' (whatever's worn out on mine-not figured out yet...)



engine compartment "tarpaper", of the "non auto-stickshift" type, pass side, and the 'front firewall' piece



cv joint BOOTS #113 501 149, four?



oil pump puller, used OK



"spin-on oil filter adapter/high pressure oil pump aftermarket" thing: "scat" or knecht (or similar)?



please respond by direct e-mail =only=, and thanks very much in advance :-)


Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required