I have a 1997 Chrysler T&C LXI. I needed an extra remote on the vehicle so I went to ebay and got one. I did not realize it was a different model than the one I have. It had a trunk button instead of the panic button. In any event, I went to program it following the instructions in the manual, namely to put ignition on and click on unlock for 5 seconds and then click on panic and release both. The new remote I bought (with trunk button) got programmed but not my original remote. I have repeated the above programming procedure on the new remote (with trunk button) but it does not chime for me and am unable to program the original remote.
Anyone experience this issue. Anybody have any detailed instructions to program both remotes from scratch. I have seen a lot of posts about traction control and program wire but am unable to locate where they are. Any help would be very much appreciated.
Thanks a bunch,
Gus