I have tried the on/off, on/off, on/off trick = nothing
I held the trip and rest buttons in during power on and the van went into a diagnostic:
Code 999 Check 1 Check 2 Check 3
But, still no P codes.
What am I doing wrong?
I have tried the on/off, on/off, on/off trick = nothing
I held the trip and rest buttons in during power on and the van went into a diagnostic:
Code 999 Check 1 Check 2 Check 3
But, still no P codes.
What am I doing wrong?
You got it backwards, try off/on, off/on, off/on.
Thanks for getting back to me. I tried the sequence exactly as you described, still nothing even after waiting 30 seconds.
so, I have another question: From off to the first on position, the odometer shows and gear shift location show. The second position ; the dash board "boots" up with bells ringing ect. The third position: is the starter.
From off to what (on) position should I be trying?
I did try the sequence from off to position 1 and off to position 2 the results were the same. nothing.
The check engine light only comes on when van is running... Is that the problem? seems like I should still see P code 55 if there was nothing to report... thanks for the help,
The on/off/on/off/on procedure does not work with that year and make of vehicle. You will need to have the error code read to find out why the CEL is lit. AutoZone will read it for free if you have one near where you live.
Bob
You want to go from "off" to "on" (what you are calling the second position)
3time within 5 seconds total time. off/on, off/on, off/on I'm not that familiar with Dodge but on Jeeps you can do the same thing, except on Jeeps there were a few years were the key cycling would not work. It may be the same with Dodge.
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.