Latest threads in General Ford Forumshow only best voted threads
| Subject | Author | Posted | Replies | |
|---|---|---|---|---|
|
|
Re: Ford Invests in More High-Mileage Vehicles
You ca try to spin it anyway you want, the fact remains your premise is flawed. If Fords, or any other manufactures vehicles did not meet all current federal standards, they could not be sold in the...
1
|
17 years ago
|
1 | |
|
|
Trans trouble
I have a 1992 Lincoln Mark works fine until you use overdrive.Once in overdrive it slips as soon as you get to normal drive it works fine.I found out it could be a TV Bushing.Where is this located and...
7
|
17 years ago
|
7 | |
|
|
new ford fusion comfort owners manual?
Hi all, i buyed new ford fusion comfort Where can I find owners manual and info for this car. Ford website constantly finds other Ford fusion. Is there any specific place on Ford site where I could...
—
|
17 years ago
|
— | |
|
|
Power steering problem
I just replaced the power valve on my 70 Cougar. I hooked up the hoses the way they came off ( I am pretty sure!) But now the steering seems real tight. Did I cross a hose from the power cylinder to...
6
|
17 years ago
|
6 | |
|
|
Ford says 38,000 accepted buyout offers
's hourly work force is shrinking to half its current size, following the announcement Wednesday that 38,000 hourly workers have agreed to accept early retirement or buyout packages this year.
—
|
17 years ago
|
— | |
|
|
Greasing distributor shaft?
I am about to replace a worn distributor in my Ford Probe '97. What kind of grease (if any) do I need to put on the gear/shaft of the new one that goes into the engine ?
1
|
17 years ago
|
1 | |
|
|
99 Expedition 4.6 Misfire
I have a 304 Code... w/ intermittent misfire. I have replaced plug & wire. Pulled injector and blew it out and replaced and ran a drop test on 1-4, which checked O.K. Afterwards, drove for about 30 mi...
2
|
17 years ago
|
2 | |
|
|
Process for battery change in Sable
I recently read the manual for my 2000 Sable and found a multi step procedure that has to be followed after changing the battery. I've asked a few people and none of them have ever seen anything like...
11
|
17 years ago
|
11 | |
|
|
diag code 1383 ford
Getting this fault code car has rough idle but drives great at high speed . code points to cam valve sensor to advance does this mean the sensor is bad or is there and actual timing problem. Help
1
|
17 years ago
|
1 | |
|
|
1.3 Endura-E lacking power at higher revs
Ive got a Mk4 fiesta, with the 1.3 Endura-E engine and just recently its been lacking power at higher revs. Anything above 3800rpm and i can feel a real dip in power. It doesnt seem to do it when i...
—
|
17 years ago
|
— | |
|
|
Electronic Vacuum Regulator (EVR) Repair
Has anyone ever taken an Electronic Vacuum Regulator apart? I was getting a 172 (EEC-IV) fault code, which indicates "system weak". A vacuum pump revealed that the EVR solenoid (which controls vacuum...
2
|
17 years ago
|
2 | |
|
|
Ford 428 SCJ engine
I have this engine and was wondering what value it may have. It was running but had a vibration in it. After taking it apart I discovered that one of the piston skirts had broken off. I have not had...
1
|
17 years ago
|
1 | |
|
|
Lincolns:
Anyone here able to point me in the right direction of a good site or forum for Lincoln fans?I want info on the Lincoln MarkVII's.thanks!
4
|
17 years ago
|
4 | |
|
|
Ford ranger axle ratio question
For the ranger years about 98 - 02: Which 4WD automatic vehicles came with the higher ratio (more engine revolutions for distance traveled) differentials? The off-road models, those with towing...
—
|
17 years ago
|
— | |
|
|
Another 99 sable question
Hi everyone, I notice that often my door ajar light stays on when the door is closed and the dome light stays on. I know it's coming from the driver door. I can't find the traditional pin switch. Does...
3
|
17 years ago
|
3 |