Best Rated threads in Chevrolet 4x4 Trucksshow all threads
| Subject | Author | Posted | Replies | |
|---|---|---|---|---|
|
|
98 ZR2 Blazer Shake @ 70 MPH
I have new tires so the balance should not be a concern, however the ride is smooth until I hit 70mph and than the whole truck starts to shake violently than about 75mph and above it smooths back out....
13
|
18 years ago
|
13 | |
|
|
1999 Blazer w/humming vibration in front end
Driving from 30mph to highway speeds I can hear a slight humming from the front end along with vibration sometimes in the floorboard. It isn't loud or anything, I just know it is there and that it is...
11
|
18 years ago
|
11 | |
|
|
Tahoe Third Seat w/ Barn Doors
Hi I have a 01 Tahoe with barn doors. I was recently given a set of third row seats. Before I start cutting up my rug to install mounting brackets, Will these seats fit? I pulled up my carpet and see...
—
|
19 years ago
|
— | |
|
|
'92 GMC failing idle HC smog test in California
My '92 GMC 1/2 Ton 4X4 (350) with 140K miles is failing the California idle smog test. The test allows 120 Maximum HC (PPM) and my truck tested 175. The oil was clean at the time of the test. The 2500...
8
|
19 years ago
|
8 | |
|
|
anybody ever rebuild an A/C compressor. e.g. an HT6?
The A/C compressor on my 96 Yukon leaks where the body sections come together like stages of a rocket (it's an HT6 compressor I think). I tightened the axial bolts which were loose, but sadly, it...
2
|
19 years ago
|
2 | |
|
|
1995 chevrolet K1500 rear axle noise
My 95 chev rear end is starting to make noise when the transmission shifts. It does it more after driving for a while. It sounds like u-joints going out except I replaced them hoping that might be it....
7
|
20 years ago
|
7 | |
|
|
Thumping in front end in 4WD
Well we have quite a bit of snow here in the Seattle area and I put the '85 K5 Blazer into 4WD of which it hasn't been in for a few months at least unless pulling out my 9000 lb boat out of the water....
9
|
20 years ago
|
9 | |
|
|
285/75R16 on a Suburban?
I'd like to upsize from my 265/75R-16 tires to 285/75R-16 on my stock suspension 1996 Sub K2500 4x4. Does anyone have tires this large on a non-raised similar vehicle? Do they rub anywhere? Thanks for...
3
|
20 years ago
|
3 | |
|
|
97 suburban 5.7L vortec misfire
I've got a 97 suburban w/5.7L vortec w/120,000 miles. Recently it's developed a misfire. OBD-II scan returns only one code indictating misfire detected on #1 cylinder (P0301) No other generic or...
3
|
20 years ago
|
3 | |
|
|
1990 Sierra Intermittent A/C Heater module
Intermittent A/C Heater with relay clicking. I understand this is a common problem with this module and why GM discontinued it. This module uses the electronic display and electronic board module...
1
|
20 years ago
|
1 | |
|
|
1990 CHEVY 1500 4X4 DOESNT ENGAGE PLEASE HELP
When I put the transfer case shifter into 4 wheel drive (either 4hi or 4lo) nothing happens. The transfercase seems fine, it goes into each gear fairly easily sometimes a mild grind? but you can feel...
3
|
20 years ago
|
3 | |
|
|
Biggest tires to fit 88-98 Chevy/GMC
What is the biggest and widest that I can fit on a 16X8 rim with out rubbing? 32"? What would that be a 285/75-16? I'd like to go as wide as possible also....any ideas fellas? Thanks ~John
8
|
20 years ago
|
8 | |
|
|
GM Truck Self Adjusting Parking Brake
Sorry if the cross posting offends anyone - but I wanted the same info to go out to both groups. I've seen this general topic discussed in both groups in the past. I have an 02 Chevy Suburban half ton...
8
|
20 years ago
|
8 | |
|
|
converting 350 TBI to 502 Ram Jet?
My truck is an "89" Silverado 2500 with a stock 350 TBI and auto trans. I've never been happy with the trucks towing power. I have a small aluminum jon boat that I trailer nearly every weekend. My...
9
|
18 years ago
|
9 | |
|
|
454 Chevy Oil Coolant Line Removal
I have a Chevy 4x4 with a 454 engine and I am trying to replace the oil coolant lines. I've replace lines on a 350, but these are different. On the 350, the lines attach directly into the oil filter...
5
|
17 years ago
|
5 | |
|
|
Cant bleed the brakes on 95 Chevy K-2500
The brakes were working fine with a good pedal. But one front pad was down to the metal. I replaced the pads on both front wheels. As soon as I finished, I stepped on the pedal and it went right to...
4
|
10 years ago
|
4 | |
|
|
Questions regarding lower rear cab mount bushings for a 91 Chevy K1500 pickup
Hi everyone, I purchased some new lower rear cab mount bushings or cushions for my 91 Chevy K1500 Pickup with a standard two door cab. The rubber bushings have what looks like a thin flat plastic ring...
9
|
15 years ago
|
9 | |
|
|
replaced fuel pump, still won't start
man, what a pain. i've got a 93 1500 TBI. Started sputtering, finally it died. Didn't hear whizzing sound at gas tank when ingnition turned. Put a few drops of fuel in the TBI. Started up but only ran...
10
|
15 years ago
|
10 | |
|
|
2003 Suburban - Electric Trailer Brake installation
I need to install an electric trailer brake controller on my 2003 suburban but I don't know what kind to buy or how to install it. My dad's Trailblazer already had a plug that you just plugged the...
2
|
15 years ago
|
2 | |
|
|
1992 S10 Blazer power window or regulator?
How do you know if its a power regulator or the motor? My drivers door window will roll down about 1/2 an inch to 1" then stop. If I wait a while and do it again it will roll down a bit farther. Going...
6
|
15 years ago
|
6 |