hello there i was wondering if anybody could help me with the removal and intallation of a heater core in a 78 canoro lt....305 v-8 motor....i just cant seem to find the rite bolts to take off to get the inside cover off of the fire wall......any suggestions would be greatly appreciated....thank you
A Chiltons auto repair book is your best friend. Take off the passenger side fender. Some people cut a hole in the wheel house to get to the bolts. The Chiltons book is more important to the task at hand though, and cheap enough to be worth the cost.
...Ron
--
68' Camaro RS 88' Firebird Formula 00' Mustang GT Verti have a haynes manual and on this it is not very helpfull.i guess what i am wondering is since this car has factory air do i need to remove this from the fire wall to get to the remaining studs they talk about? so far i have only found one. there must be more some where.thank you for your response i will look into getting a chiltons......thanks again
Yes, there are more studs. That's why I said that you either have to remove the fender or cut a largish hole in the wheel house, to get to the offending nuts.
...Ron
--
68' Camaro RS 88' Firebird Formula 00' Mustang GT Verti have taken the tire off removed the inner fender........and still only one stud with a nut..i have removed the blower motor..still nothing the only thing i can see is removing the factory air......something i dont want to do but if that is the ticket then ok.......i just dont want to undeal thar if i dont need to......thanks again for all your help
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.