Hi i was looking at my manifold i think thats what it is the bit that comes out of the enjine 6 outlets cylinders into the exhaust, noticed it was really rusty anyone know where to get a second hand one 248 strait 6 ohc nissan regards Frank
They will if there Cast Iron or steel tube.
Assuming it's cast iron and the rust is surface rather than structural, run the engine until it's nice and hot then slap a few coats of neat Brasso on with an old paintbrush. Dries to a nice creamy colour and miles cheaper than any of the exhaust paints. Old trick.
Geoff MacK
Oh, sounds good. Time to tart up the Saabs manifold.
MeatballTurbo ( snipped-for-privacy@bouncing-czechs.com) gurgled happily, sounding much like they were saying :
In article , snipped-for-privacy@achapman.freeisp.co.uk spouted forth into uk.rec.cars.classic...
Nah, I'm wise to that, after a boost hose blew off, just as I'm acceleratig up a hill. Had to work really carefully to screw the hose clip back down, without touching the turbo. Still burnt myself a little though.
MeatballTurbo ( snipped-for-privacy@bouncing-czechs.com) gurgled happily, sounding much like they were saying :
Familiarity breeds contempt....
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.