94 limited serpentine tensioner pulley

How hard is it to replace the bearings in the serpentine belt tensioner pulley? Mine is squealing like a pig.

Reply to
Mike Lapke
Loading thread data ...

Actually, quite easy. Take off the belt, then take out the bolt holding the pulley. the bearing is "lightly" pressed into the pulley and comes out pretty easily. Reinstall via the reverse. While you're at it, change the bearing on the fixed idler pulley the same way.

Reply to
rakster

Unless the bearing is shot you can just re-grease it by prying the side off with a small screwdriver, add grease, then press side back on. This worked great for me on my Explorer & Ranger.

SMC

Reply to
MOTO

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.