My 1996 bronco has a clunk the tranny or drive shaft. at stopping and taking off, any way to stop it. is there some way of packing grease in the drive shaft? thanks
Clunk in bronco
Mar 17, 2005
Last reply: 21 years ago
1 Replies
If it's the driveshaft, take it out, mark it, and separate it at the slip yoke. Grease the splines heavily, and put it back together, using new clamps on the rubber boot. Be sure to mark it before taking it apart, in order to line the splines up the same way. You can also drill and tap and install a zerk fitting in the outer part of the shaft.
Good luck,
Spdloader
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required