General Motors Forum

11153 Threads Posts
to

2003 gelling (sludge) I4 Camry

I do not own a Toyota at this time so I have not been following this very closely. However my mother has a 2003 4cyl Ca...
2 comments posted 20yrs
posted by DoubleTap
2 comments posted 20yrs posted by DoubleTap

Do I need new Shocks or Bushings or Whaat?

97 Pontiac GA 3.1 V6 with 130k+ miles. The car rides nice, tight and smooth until I hit a square edged rut in the road...
1 comments posted 20yrs
posted by tyytt2
1 comments posted 20yrs posted by tyytt2

Impala A/C and heat help

I have a 2001 Impala. The a/c/heat has 6 positions, however the air and heat will not blow until it is in the 3rd posit...
6 comments posted 20yrs
posted by Matthew.S.Adler
6 comments posted 20yrs posted by Matthew.S.Adler

2007 Chevrolet Silverado

If you havent seen the 2007 Chevrolet Silverado you are not missing anything. You can see it by going to this website....
0 comments posted 20yrs
posted by gmman200
0 comments posted 20yrs posted by gmman200

Buick LaSabre

Wife was driving home in her 93 LaSabre tonight. She drives this route 5 days a week to and from work. She said she was...
4 comments posted 20yrs
posted by T&L
4 comments posted 20yrs posted by T&L

metro fuel pump?

Here's one that's got me stumped. My 1997 Metro (4 cyl) will just cut out while I'm driving. The problem is intermitten...
2 comments posted 20yrs
posted by u24399
2 comments posted 20yrs posted by u24399

Conversation over -- no more GM cars

I was soured on GM cars by the quality of my 2001 LeSabre. It has more than normal repairs. Looking at a few other bran...
22 comments posted 20yrs
posted by esp
22 comments posted 20yrs posted by esp

V5 compressor seal replacement

My 1996 S10's V5 compressor seems to have a bad seal behind the clutch. I evacuated it and added one can of R134a and i...
5 comments posted 20yrs
posted by sound
5 comments posted 20yrs posted by sound

2.2 L Service Engine Light Reset?

Whenever I lug the engine in my 2003 S-10 the SES light will pop on. It's easy to do with the 4 cylinder. Just forget a...
1 comments posted 20yrs
posted by ka0mgm
1 comments posted 20yrs posted by ka0mgm

Re: '93 Lumina won't start

Hey did you test the injectors? i had one bad one and the car wouldnt start ,even though the othes are good 1 bad one wi...
1 comments posted 20yrs
posted by FAQTO.2bdyif
1 comments posted 20yrs posted by FAQTO.2bdyif

Constant Transmission Fluid Drip

This is an 89 Chevy Caprice station wagon with the 307 engine (olds engine used in chevy). It has the 3 speed automatic...
5 comments posted 20yrs
posted by maradcliff
5 comments posted 20yrs posted by maradcliff

JB Weld on Exhaust Manifold ?????

I was reading another older thread on her about someone that used JB Weld on a cracked engine block. They said it worke...
15 comments posted 20yrs
posted by maradcliff
15 comments posted 20yrs posted by maradcliff