Help with YJ lift

There's really no way he can do this much lift without an SYE & CV shaft. I've got this lift set up with Dynatrac axles and an Atlas II. The rear axle was dialed in spot on the money ant it still can exhibit a trace of vibration under different loads.

practically

Hey guys, what's a SYE? I'm considering a 4" lift on my CJ and the only mod I thought I'd need is a drop pitman arm.

Thanks,

bill

Slip Yoke Eliminator.... but I don't believe it's an issue with CJ's. On the Wranglers, it reduces the transfer case tail shaft length, allowing you to install a longer rear drive shaft which will reduce vibration (reduces the degree of angle between transfer case and axle).

Dave

If you add a 1" motor mount lift it might give you a little help by pointing the tranny lower, but at these angles you will still go through u-joints. Even if this works I would get the SYE soon. Jim F.

They do. The original post is about a YJ, with leaf springs. Real Jeeps also have the drive shaft bolted to the tcase. They have round head lamps too.

Is it me or are the newer TJs with round head lamps not as bright as the YJ lights? Somehow I get the perception that the square lights seem brighter also with the high beams on. I used to have an old Nissan truck with the

720 pickup body and it had 4 square lights that really worked well and were exceptionally bright.

The drivers of which one? :-)

So what does this have to do with square lights again? :0)

LOL!