I'm still not getting back any error codes. I installed a new distributor. Made sure I cleaned out the pin holes in the connector on the wiring harness. What else to do?
Is there a way to test other parts (coil, etc) with a multimeter to make sure it's working correctly?
I sure hate to just start throwing parts at it.
Thanks in advance,
bill
Ok, I figured it out. I didn't set the distributor on the COMPRESSION stroke. Duhhh!!!.
Back in business.
Now, on this week to check the injectors.
Thanks all,
Bill
distributor.
You will something like a Haynes manual. There is a way to test the coil with an ohm meter.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required